Anagram & Information om | Engelska ordet BARBETTES

Exempel på hur man kan använda BARBETTES i en mening

• The armour of the gun turrets and their barbettes was 6 inches thick while the casemate armour was 5 inches thick.
• The gun turrets had 12 inch thick faces, while the supporting barbettes had 10 inch thick armor plating.
• Charleston was armed with two /35 caliber Mark 3 guns, one each in bow and stern barbettes, and six /30 caliber Mark 3 guns in sponsons along the sides.
• The main battery turrets were 10 in thick, atop 12-inch barbettes, and the casemate battery was protected with 6 in of Krupp steel.
• While the preceding Royal Sovereign-class battleships had revolutionised and stabilised British battleship design by introducing the high-freeboard battleship with four main-battery guns in twin mountings in barbettes fore and aft, it was the Majestics that settled on the 12 in main battery and began the practice of mounting armoured gunhouses over the barbettes; these gunhouses, although very different from the old-style, heavy, circular gun turrets that preceded them, would themselves become known as "turrets" and became the standard on warships worldwide.
• The designers reasoned that since the barbettes were behind the belt and a transverse bulkhead, weight could be saved by reducing the level of direct protection.
• Transverse bulkheads 4 to 6 inches thick ran at an angle from the ends of the thickest part of the waterline belt to 'A' and 'Y' barbettes.
• Transverse bulkheads 4 to 6 inches thick ran at an angle from the ends of the thickest part of the waterline belt to 'A' and 'Y' barbettes.
• Transverse bulkheads 4 to 6 inches thick ran at an angle from the ends of the thickest part of the waterline belt to 'A' and 'Y' barbettes.
• Transverse bulkheads 4 to 6 inches thick ran at an angle from the ends of the thickest part of the waterline belt to 'A' and 'Y' barbettes.
• Hoods half-sisters mounted their guns exposed on top of barbettes, a much lighter arrangement that allowed their freeboard to be substantially increased.
• The ships of the Canopus class had four 12-inch 35-calibre guns mounted in twin-gun turrets fore and aft; these guns were mounted in circular barbettes that allowed all-around loading, although at a fixed elevation.
• The ship was fitted with four submerged 18-inch (450 mm) torpedo tubes, two on each broadside abreast the barbettes.
• The armour bulkheads at each end of the ship angled inwards from the ends of the midships armoured belts to the end barbettes and were three inches thick.
• 1 : initial production version, the majority were produced with empty TOGS barbettes for the conversion programme to retrofit the system.
• The defensive and offensive armament was revised, and the bomber's weaponry expanded to twin ShKAS guns in the nose, nacelle barbettes and tail turrets and a dorsal turret with a ShVAK; this design eliminated the ventral gun.
• The main barbettes were protected by seven inches of armour as were the ammunition hoists, although the armour for those thinned to two inches between the lower and main decks.
• The barbettes were protected by six inches of armour as were the ammunition hoists, although the armour for those thinned to three inches between the armour belt.
• 25-inch breechloaders; introduction of secondary armament; armament housed in central citadels; armament housed in barbettes and in turrets; and development of the torpedo.
• The RML guns were mounted in concrete open barbettes and 6-inch guns on Hydropneumatic disappearing carriages.

Förberedelsen av sidan tog: 79,67 ms.