Synonymer & Anagram | Engelska ordet INRUSH
INRUSH
Antal bokstäver
6
Är palindrom
Nej
Sök efter INRUSH på:
Wikipedia
(Svenska) Wiktionary
(Svenska) Wikipedia
(Engelska) Wiktionary
(Engelska) Google Answers
(Engelska) Britannica
(Engelska)
(Svenska) Wiktionary
(Svenska) Wikipedia
(Engelska) Wiktionary
(Engelska) Google Answers
(Engelska) Britannica
(Engelska)
Exempel på hur du använder INRUSH i en mening
- On April 19, 1892, the expected inrush of settlers did materialize; by sundown some 400 claims had been posted.
- The second, more powerful explosion, designed to sink the boat, caused a huge inrush of seawater that drowned Pereira.
- To reduce the inrush current, larger motors will have reduced-voltage starters or adjustable-speed drives in order to minimise voltage dips to the power supply.
- The sudden inrush of water into the graving dock pushed the carrier into the forward end, damaging the bow structure below the waterline and requiring repairs in drydock.
- NTC materials are used to create inrush current limiters (because they present higher initial resistance until the current limiter reaches quiescent temperature), temperature sensors and thermistors.
- Early reports blamed a sudden inrush of firedamp from old workings which pitmen had inadvertently broken into.
- Worst-case inrush happens when the primary winding is connected at an instant around the zero crossing of the primary voltage (which for a pure inductance would be the current maximum in the AC cycle) and if the polarity of the voltage half-cycle has the same polarity as the remanence in the iron core has (the magnetic remanence was left high from a preceding half cycle).
- For example, a popular -inch 150 psi sprinkler valve, intended for 24 VAC (50–60 Hz) residential systems, has a momentary inrush of 7.
- Where it is necessary to limit the starting inrush current (where the motor is large compared with the short-circuit capacity of the supply), the motor is started at reduced voltage using either series inductors, an autotransformer, thyristors, or other devices.
- Pre-charge of the powerline voltages in a high voltage DC application is a preliminary mode which limits the inrush current during the power up procedure.
- They can be equipped with devices to synchronize closing and/or opening, to limit the overvoltages and the inrush currents from the lines, the unloaded transformers, the shunt reactances and the capacitor banks.
- Negative temperature coefficient (NTC) thermistors and fixed resistors are often used to limit inrush current.
- A BMS may also feature a precharge system allowing a safe way to connect the battery to different loads and eliminating the excessive inrush currents to load capacitors.
- With the PC industry rising from the 1980s in Taiwan, its NTC thermistor is adapted as the inrush current limiter in switched-mode power supply to suppress the inrush current when power supply turns on, and the varistor protects the circuit from damaged by surge current occasionally occurred in the electricity network.
- After all it is this lateral inrush of fluid, which “sweeps up” the grains in the grooves and redeposits them in long parallel ridges underneath the lifting turbulences.
- The accounts given by some of those who were aboard the Merksworth differ in minor details, though they are unanimous in that they were ahead until the nose of the Manly was poked into the midship part of their ship, smashing the bridge and some of the upper works It came as a surprise, and after realising that they had been struck nobody suggested that the blow was serious until the hissing caused by the inrush of water below into the boiler room was heard, and it came in quickly, for before the Merksworth could reach Kirribilli Point she was doomed, and the best that could be done was done under the circumstances, namely, head her for the nearest land and jam her head there, thus saving risking the lives of the men The other steamer, Manly, was by that time well up tho harbour on her way to the Manly wharf “They hit us on our starboard side," said one of the crew of the Merksworth, “and we didn't think there was much in it, but she has a projecting propeller head, and that must have rammed us underneath" And that is the accepted theory of the cause of the sinking of the Merksworth
. - A party under Lieutenant Herbert Heath attempted to unroll a collision mat down the side of the ship to patch the hole and slow the inrush of water, but by the time they could manhandle it into position they were standing in water, and had to abandon the attempt.
Förberedelsen av sidan tog: 183,38 ms.